Safeboot

So, you've forgotten your password?
Don't worry! There's a simple fix - simply boot your RoboPad into safeboot mode by connecting the safeboot pin (marked SB on the board) to the 3.3v pin (marked 3V3) and leaving them connected for at least the first 5 seconds after boot. Once this is done, the RoboPad will form a wifi network called "RoboPad-safe-boot" with no password. Upon connecting to this you will be greated with the safeboot page, which will allow you to change the password via the management page or update the firmware.

Note: If you recieve an error when trying to access the management page, please ensure that you are running a version of RoboPad newer than 2.2 by uploading a new version of the firmware to the device.