Inverter Node
Jump to navigation
Jump to search
|
|
Inputs
|
Outputs
|
| Version Introduced 2.2 |
The Signal Inverter Node is a very simple node that consumes an input signal through the input port in, and then inverts that signal around 0.5, clipping the result to between 0 and 1.
This is one of the few nodes designed to be used in simple signalling scenarios where all you really care about are values between 0 and 1.
Inverter Nodes were introduced in firmware version 2.2. They have no configurable settings.
Example Behaviour Table
The table below shows some example inputs and the outputs that they would produce.
| Input | Output | Comments |
|---|---|---|
| 0 | 1 | |
| 1 | 0 | |
| 0.25 | 0.75 | |
| 1.2 | 0 | Here the true inversion value (-0.2) is clipped to 0. |
| -3 | 1 | Here the true inversion value (3.5) is clipped to 1. |